You can reset your iPod by holding down both the Menu button and the center button for a few seconds. Reset The iPod Nano – This was probably the most common initial response, and was, of course, completely useless. Since I had the file in the right folder, that wasn’t the problem. dll file that is necessary for USB 2.0 drivers to work. dll file – One website recommended checking to see if you were missing a. But, surprise, surprise, I got the same error later on. I tried that, and it seemed to work, once. You right click on each of the entries under Universal Serial Bus controllers and delete them. Reinstall all of your USB drivers – One forum recommended deleting all of your USB drivers from the Device Manager and reinstalling them all after you reboot. Other people were experiencing similar problems – lots of people (which is probably why you’re here too)! The solutions offered seemed to make sense considering the errors that were popping up. I typed in “USB Device Not Recognized” and iPod Nano in Google and got a variety of results. So, what to do? As any relatively tech savvy geek would, I turned to the internet. But, again, since it played fine for me when it wasn’t connected, I didn’t think the iPod was the problem. This seemed to indicate that my Nano was malfunctioning. This last Windows error caused me the most grief. For assistance in solving this problem, click this message.”) (Text: “USB Device Not Recognized – One of the USB devices attached to this computer has malfunctioned, and Windows does not recognize it. Even so, it seems to indicate there may be a problem with my ports or maybe with the USB drivers (more on this below). I knew this error didn’t make much sense since all of the ports on my computer are USB 2.0. For a list of available ports, click here.”) (Text: “This device can perform faster – This USB device can perform faster if you connect it to a Hi-Speed USB 2.0 port. Even so, there were two more error messages I’d get that didn’t make much sense to me, but do explain why some people recommend some completley useless solutions: You can also see in the above photo that the USB connection icon in the taskbar is weird looking compared to how it normally looks when it corrects okay:Īnd since my iPod played just fine, I was skeptical that the problem was with the iPod. Here’s a photo of my iPod connecting to iTunes just fine: Since my iPod worked 50% of the time, I knew deep down inside that this just didn’t make sense. Use the iPod Updater to restore the iPod to factory settings.”) (Text: “iTunes cannot read the contents of the iPod “CRAGUNPOD”. I also occasionally got this error in ITunes, which really confused me: Your new hardware might not work properly.”) (Text: “Found New Hardware – A problem occurred during hardware installation. The other 50% of the time I’d plug it in via the USB cable and I’d get the following messages:įirst I’d get this lovely one from Windows: About 50% of the time I’d plug it into my computer and it would work fine. I quickly checked Apple’s website to see if my Nano was still under warranty, which it was, so I breathed a little easier, but I still didn’t know what was causing the problem with my iPod. So, when I started experience bizarre errors with my Nano about 3 months ago, I started to get a little worried. It’s not the most full-featured mp3 player on the market, but it does have a slick interface and works really well… for the most part. I’ve had my iPod Nano for just under a year now and really like it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |